Installing A Power Supply Module; Figure 20. Removing Filler Module - Intel MFSYS25V2 Service Manual

Three power supply modules support four to six compute modules (in any slot) plus all
other modules in the system.
Any additional power supply modules above the minimum required (based on
configuration) provide redundancy.

Installing a Power Supply Module

To install a power supply module, follow these steps:
1. Review the safety and ESD information at the beginning of this manual and in the
appendices.
2. Locate the power supply module bay and remove any installed module or filler
module.
— For instructions on removing a power supply module, see
— To remove a filler module, press the retention lever latch (see letter "A" in
®
Intel Modular Server System Service Guide
Supply Module" on page
Figure 20) to release the filler module from the module bay. Slide the filler
module out of the bay (see letter "B" in

Figure 20. Removing Filler Module

34.
Figure 20).
A
"Removing a Power
B
AF002420
33