Remove Option Boards And Expansion Board, If Installed - HP Model 744 - VME Workstation Manual

Installing the HCRX/VME Graphics Hardware

2. Remove option boards and expansion board, if installed.

If any option boards or the GSC expansion board are installed on the SBC, remove them
as follows:
a.
If any option boards are installed on the SBC, use a #1 Pozidriv screwdriver to
remove their two mounting screws and carefully disconnect them, as shown in
Figure 2–2.
Option Board
Figure 2–2. Removing Option Boards and GSC Expansion Board
2–4
GSC Expansion Board