Chapter 3
Figure 3-5. Satellite Chassis with Open Cover
5. Pull back one of the spring-loaded hinge pins on the underside of the
cover and lift the cover off.
6. Set the cover aside.
Looking down into the satellite chassis, you can see the processor and
terminator boards on the system board.
Remove the Terminator Board
1. Determine which terminator board (or boards) you will be removing from
your system.
You must remove one terminator board for each 200 MHz/1 MB processor
board you are adding. Refer to Table 2-1 in "Plan the Upgrade" and to
Figure 3-6 that follows to determine which terminator board (or boards)
you need to remove from your system.
12
Perform the Upgrade