Connecting the HP StoreOnce 2700 Backup system
Figure 10 Rear view of the HP StoreOnce 2700 Backup system
1.
RAID Controller – external port is unused
3.
Power supply bay 1
5.
iLO4 port, do not use for data connection
7.
Video/monitor connector
9.
1 Gbit ethernet network ports 2, 3 and 4
Attaching the security bezel
The product is supplied with a security bezel that is placed inside the box, and not delivered
pre-installed on the servers. Once the server is installed within the rack, the security bezel may be
clipped to the front of the unit. No special tools are required to do this.
NOTE:
The key to lock the bezel is attached to the back of the security bezel. Only one key is
supplied.
Figure 1 1 Attaching the security bezel
Connecting to the expansion enclosure (HP StoreOnce 4500 and 4700)
Install the rail kit and expansion module(s) immediately below or above the HP StoreOnce Backup
system.
HP StoreOnce 4700 Backup system: The first 24TB disk enclosure must be installed at the
same time as the head server unit and connected to the correct RAID card as described in
Connecting the first storage enclosure at installation (page
enclosures, HP StoreOnce 4500/4700 24TB Capacity Kit (BB881A), may be installed at the
same time or added later. Expansion enclosures may be daisy chained. The user is advised
18
Installing and cabling the HP StoreOnce Backup system
2.
USB connectors (4)
4.
Power supply bay 2 (optional)
6.
Serial connector
8.
1 Gbit ethernet network port 1, connect for
Quick Install
16). Up to seven 24TB expansion