Permanently Set The Console Path And Monitor Type With The Boot Console Handler; Model 744 - HP Model 744 - VME Workstation Manual

2. Permanently set the console path and monitor type with the boot
console handler.
The procedure for setting the console path and monitor type is differs according to the
model SBC on which you installed the HCRX board. Follow the procedure appropriate
for your SBC.

Model 744:

When you selected the boot console in the Step 1, the settings were stored in the Boot
ROM. You only need to use the following procedure if you decide to change the boot
console settings.
a.
When the Boot Console Handler's Main Menu is displayed, type
pa con graphics(n)
where n is: 0 for onboard graphics,
b.
At the Main Menu, type:
reset
c.
As the system boots, a message similar to the following appears:
If monitor selection is correct, press any key other
than <TAB> or will time out in 10 seconds.
If monitor selection is wrong, press <TAB> to start
monitor selection poll loop.
If you press
available monitor types one at a time.
Enter
1 for HCRX graphics, or
2 for an 8–plane graphics card.
to restart the system
Enter
or wait more than 10 seconds, the system cycles through all of the
Tab
Setting Your Graphics Configuration
3–7