2. Set the temperature depending upon the selected operation mode (see
the chapter "Setting the Temperature").
Attention! If you are using the appliance as a freezing unit: Please wait
prior to putting the foodstuff to be frozen, until the freezer interior
temperature has attained -18 °C, or until the red warning display goes
Attention! If you are using this appliance as a cooling unit, after it has
been used as a freezing unit: Please wait until the temperature has
reached 0 °C before putting the foodstuff to be cooled in the appliance.
1. Press either the „+" (WARMER) or „-" (COLDER) button.
The temperature display switches over and the DESIRED temperature
currently set flashes on the temperature display.
2. To adjust to a warmer temperature, press the „+" (WARMER) button. To
adjust to a colder temperature, press the „-" (COLDER) button. The
changed setting is immediately displayed on the temperature display.
Each time one of the two buttons is pressed again the DESIRED temper-
ature is adjusted by 1 °C.
Note: From a food safety point of view, -18 °C should be considered
cold enough as a storage temperature.
When the buttons are not further pressed after an adjustment has been
made, after a short period (approx. 5 sec.) the temperature display swit-
ches over and again displays the ACTUAL temperature in the freezer
compartment. The display changes from flashing to continuous illumi-
The following DESIRED temperature settings are possible:
• Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps;
• Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps;
Attention! If the operation mode "Cooling" is selected, the ambient
temperature at the installation place must be at least 2 °C higher than
the preset DESIRED temperature.
Important! Please regularly check that the storage temperature is
being maintained by checking the red warning light and the tempera-