Removing An 820-Watt Power Supply - 3Com 3CB9E7 - CoreBuilder 9000 Chassis Switch Getting Started Manual

Removing an 820-watt Power Supply

The CoreBuilder 9000 Enterprise Switch can
accommodate the following number of 820-watt
power supplies:
The 8-slot chassis can accommodate up to three
820-watt modular load-sharing power supplies.
The 16-slot chassis can accommodate up to four
820-watt modular load-sharing power supplies.
Figure 36 shows an 820-watt AC power supply in the
16-slot chassis. Figure 37 shows an 820-watt AC
power supply in an 8-slot chassis.
The figures in this section illustrate the 16-slot chassis.
Unless otherwise noted, the same procedures apply
to the 8-slot chassis, except that the power supplies
are located in a different area in the chassis. You
install and remove power supplies in the same
manner, using the same steps.
Removing and Replacing a Power Supply
Figure 36 CoreBuilder 9000 16-slot Chassis Power Supply
Location with an 820-watt Power Supply Installed
Power supply Power supply
(in slot 1) slot 3
Power supply Power supply
slot 2
77
slot 4