Figure 2.3 Block Diagram; Setting Jumpers - Advantech PCM-3362 User Manual

Pc/104-plus sbc with intel atom n450, vga, lcd, lan, usb2.0, sata, and on-board flash

Hide thumbs Also See for PCM-3362:

Table of Contents

2.4

You may configure your card to match the needs of your application by setting jump-

ers. A jumper is a metal bridge used to close an electric circuit. It consists of two

metal pins and a small metal clip (often protected by a plastic cover) that slides over

the pins to connect them. To "close" a jumper, you connect the pins with the clip. To

"open" a jumper, you remove the clip. Sometimes a jumper will have three pins,

labeled 1, 2 and 3. In this case you would connect either pins 1 and 2, or 2 and 3.

PCM-3362 User Manual

Figure 2.3 Block diagram

Table of Contents