Displaying 802.1X Statistics And Status - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 10 Configuring 802.1x Port-Based Authentication
Note You must configure the RADIUS server to perform accounting tasks, such as logging start, stop, and
interim-update messages and time stamps. To turn on these functions, enable logging of
"Update/Watchdog packets from this AAA client" in your RADIUS server Network Configuration tab.
Next, enable "CVS RADIUS Accounting" in your RADIUS server System Configuration tab.
Beginning in privileged EXEC mode, follow these steps to configure 802.1x accounting after AAA is
enabled on your switch. This procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3
aaa accounting dot1x default
start-stop group radius
Step 4
aaa accounting system default
start-stop group radius
Step 5
end
Step 6 show running-config
Step 7 copy running-config startup-config
Use the show radius statistics privileged EXEC command to display the number of RADIUS messages
that do not receive the accounting response message.
This example shows how to configure 802.1x accounting. The first command configures the RADIUS
server, specifying 1813 as the UDP port for accounting:
Switch(config)# radius-server host 172.120.39.46 auth-port 1812 acct-port 1813 key rad123
Switch(config)# aaa accounting dot1x default start-stop group radius
Switch(config)# aaa accounting system default start-stop group radius

Displaying 802.1x Statistics and Status

To display 802.1x statistics for all interfaces, use the show dot1x all statistics privileged EXEC
command. To display 802.1x statistics for a specific interface, use the show dot1x statistics interface
interface-id privileged EXEC command.
To display the 802.1x administrative and operational status for the switch, use the show dot1x all
privileged EXEC command. To display the 802.1x administrative and operational status for a specific
interface, use the show dot1x interface interface-id privileged EXEC command.
For detailed information about the fields in these displays, refer to the command reference for this
release.
78-11380-10
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
Enable 802.1x accounting using the list of all RADIUS servers.
(Optional) Enables system accounting (using the list of all RADIUS
servers) and generates system accounting reload event messages when the
switch reloads.
Return to privileged EXEc mode.
Verify your entries.
(Optional) Saves your entries in the configuration file.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Displaying 802.1x Statistics and Status
10-21