Installation - Sharp FO-3150 Service Manual

FO-3150U/C

[4] Installation

1. Site selection
Take the following points into consideration when selecting a site for this
model.
ENVIRONMENT
•
The machine must be installed on a level surface.
•
Keep the machine away from air conditioners, heaters, direct sun-
light, and dust.
•
Provide easy access to the front, back, and sides of the machine. In
particular, keep the area in front of the machine clear, or the original
document may jam as it comes out after scanning.
•
The temperature should be between 10 and 30 C (50 and 86 F).
•
The humidity should be between 20% and 85% (without condensa-
tion).
ELECTRICITY
AC 120 V, 60 Hz, grounded (3-prong) AC outlet is required.
Caution!
•
Connection to a power source other than that specified will cause
damage to the equipment and is not covered under the warranty.
•
If your area experiences a high incidence of lightning or power surges,
we recommend that you install a surge protector for the power and
telephone lines. Surge protectors can be purchased at most telephone
specialty stores
TELEPHONE SOCKET
A standard RJ11C telephone socket must be located near the machine.
This is the telephone socket commonly used in most homes and offices.
•
Plugging the fax machine into a socket which is not an RJ11C socket
may result in damage to the machine or your telephone system. If
you do not know what kind of socket you have, or need to have one
installed, contact the telephone company.
If the machine is moved from a cold to a warm place...
If the machine is moved from a cold to a warm place, it is possible that
the reading glass may fog up, preventing proper scanning of documents
for transmission. To remove the fog, turn on the power and wait approxi-
mately 2 hours before using the machine.
2. Installing the toner cartridge
The laser printer in your fax machine uses a toner cartridge and a
drum cartridge. The drum cartridge comes pre-installed, and the
toner cartridge must be installed.
The starter toner cartridge
included with your fax can
print approximately 1,800
letter-size pages at 4%
page coverage.
• The drum cartridge can print approximately 20,000 letter-size
pages. When replacing the drum cartridge, use a Sharp
FO-29DR drum cartridge.
Follow the steps below to install the toner cartridge and prepare the
drum cartridge.
1 Grasp the print compartment cover at both sides as shown, and
pull up to open the cover.
• Caution! The fusing unit inside the print compartment becomes
very hot during operation. Do not touch the inside of the
compartment or the paper guide on the underside of the print
compartment cover.
2 The drum cartridge has been installed at the factory. Remove the
protective board from above the drum cartridge, and then grasp the
tabs on the drum cartridge handle with both hands and gently pull
the cartridge out of the machine. Remove the sheet of protective
paper from the cartridge and then insert it back into the machine.
• When removing the drum cartridge, be careful not the tear the
paper or leave any pieces of paper in the machine.
1 – 4
When replacing the toner
cartridge, use a Sharp
FO-29ND toner cartridge can
print about 3,700 letter-size
pages at 4% coverage.