Paper Feed Solenoid; Sleeve Release Lever; Pe Lever (Paper Empty Lever) - Sharp FO-3150 Service Manual

12. Paper feed solenoid

1 Remove connector.
2 Remove lever release spring which is attached to sleeve release
lever.
3 Remove one screw.
4 Slide paper feed solenoid and remove it from between curved mirror
ass'y and the upper frame.
Note: At that time, do not disassemble curved mirror ass'y. (Never
loosen the fixing screw.) If it is removed or shifted, precise
adjustments are required, which cannot be performed in the
market.
Note for assembly
• When lever release spring is completely removed, and when it is at-
tached again, hang the one side of lever release spring on paper feed
solenoid before attaching paper feed solenoid to the upper frame.
• When attaching the paper feed solenoid, refer to the above figure for
the correct fixing position.
• Be careful that the arm of paper feed solenoid is under sleeve release
lever.
3 Paper feed
Never loosen
solenoid
4
2
Lever release
spring

Sleeve release lever

Be careful
to the direction
of the hook
Paper feed
solenoid
Arm
Sleeve release
lever
Arm
Sleeve release
lever
Fig. 20
1
Curved mirror
ass'y
Spring
13. Sleeve release lever
1 Rotate sleeve release lever in the direction (A) and remove the shaft
of sleeve release lever from the notch of the upper frame and re-
move it from the upper frame.
(A)

14. PE lever (Paper Empty lever)

1 Slightly turn the PE lever in the direction of arrow (A) , and slide it in
the direction of arrow (B).
2 Remove the notch section of PE lever shaft from the notch section
of the upper frame as shown in arrow (C) , and remove PE lever.
3 – 19
FO-3150U/C
Sleeve release
lever
1
Notch
1
Fig. 21
PE lever
1
(C)
(A)
(B)
Notch section
2
Fig. 22