Pin Actuator (Paper In Detection Lever); Pout Actuator (Paper Out Detection Lever) - Sharp FO-3150 Service Manual

FO-3150U/C
Separation
electrode
Fig. 38
6 Hold the right side of separation electrode with tweezers and disen-
gage it from the lower frame boss and remove upward as follows.
Separation electrode
Separation electrode
Fig. 39
Note : Drum earth electrode so that it is on the terminal on the PWB unit
as follows.
< NO GOOD >
Fig. 40
Bent section
6
Boss
6
< GOOD >

27. PIN actuator (Paper in detection lever)

1 Turn the PIN actuator and slide the thin section of the shaft in the
arrow (A) direction and remove it from the lower frame.

28. POUT actuator (Paper out detection lever)

1 Turn the POUT actuator and slide the thin section of the shaft in the
arrow (A) direction and remove it from the lower frame.
Note for assembly
•
When attaching the PWB unit to the lower frame, put the lower frame
upside down. Face the PIN actuators and POUT actuator as shown in
the figure below.
3 – 24
PIN actuator
1
(A)
Fig. 41
POUT actuator
1
(A)
Fig. 42
Fig. 43