Sharp FO-3150 Service Manual page 12

FO-3150U/C
3 Grasp the print compartment cover at both sides as shown, and
pull up to open the cover.
• Caution!
The fusing unit inside the print compartment becomes very hot
during operation. Be careful not to touch the inside of the
compartment.
4 Grasp the finger hold on the toner cartridge handle where it is
marked PUSH, and pull the handle out. Hold the handle and pull
the toner cartridge out of the compartment.
• Place the toner cartridge on a sheet of paper on a level surface.
5 Grasp the tabs on the drum cartridge handle with both hands and
gently pull the cartridge out of the machine.
6 Wrap the drum cartridge in a large sheet of paper as shown at
right so that the green drum section is shielded from light, and
place it gently on a level surface.
• Do not touch the green drum in the drum cartridge. This will
damage the drum surface.
• Do not expose the drum to direct light. This will damage the
drum.
7 Gently pull the jammed paper out of the machine.
• If needed, turn the wheel on the right side of the fusing unit to
eject the paper from the machine.
• Caution!
Do not use excessive force to pull the jammed paper out. If the
paper tears and a piece remains inside the machine, a service
call may be necessary to remove the remaining piece.
8 Replace the drum cartridge, holding the tabs on the drum car-
tridge handle with both hands.
• To insert the cartridge, align the guides on the cartridge with the
runners on the sides of the compartment.
9 Replace the toner cartridge and close the print compartment
cover. (Refer to Installing the Toner Cartridge.)
1 – 10
Fusing unit
Wheel