Replacing Parts; Fixed Knife And Movable Knife (8560A Only) - Brother Z-8550A Instruction Manual

11. REPLACING PARTS

11. REPLACING PARTS
Replacement of parts should only be carried out by a qualified technician.
Turn off the power switch and disconnect the power cord from the wall outlet before replacing any parts, otherwise
the machine may operate if the treadle is pressed by mistake, which could result in injury.
When removing the needle plate, auxiliary needle plate and knife unit, use a screwdriver that matches the size of
the screw heads.
If a screwdriver with a size that does not match is used, it may damage the screw heads and cause personal injury
or damage to the sewing articles.
Use only the proper replacement parts as specified by Brother.

11-1. Fixed knife and movable knife (8560A only)

55
CAUTION
<Removal>
3490M
1. Remove the two screws (1), and then remove the knife
unit (2).
2. Remove the four screws (3), and then remove the knife
holder (4).
3. Remove the fixed knife (5) and the movable knife (6).
<Installation>
1. Install the fixed knife (5) and the movable knife (6) to the
knife base plate (7).
2. Install the knife holder (4) with the four screws (3).
3. Install the needle plate (8) if it is not already installed.
4. Install the knife unit (2) securely to the edge of the
needle plate (8) with the two screws (1).
3491M
Z-8550A, 8560A