Installation - Brother Z-8550A Instruction Manual

4. INSTALLATION

Machine installation should only be carried out by a
qualified technician.
Contact your Brother dealer or a qualified electrician
for any electrical work that may need to be done.
The sewing machine weighs approximately 49 kg.
The installation should be carried out by two or more
people.
About the machine set-up location
• Do not set up this sewing machine near other equipment
such as televisions, radios or cordless telephones, otherwise
such equipment may be affected by electronic interference
from the sewing machine.
• The sewing machine should be plugged directly into an AC
wall outlet. Operation problems may result if extension cords
are used.
Carrying the machine
• The machine should be carried by the arm by two people as
shown in the illustration.
* Hold the motor cover (A) by hand also so that the pulley
does not rotate.
Tilting back the machine head
• Hold section (B) with your foot so that the table does not
move, and then push the arm with both hands to tilt back the
machine head.
Returning the machine head to the upright position
1. Clear away any tools, etc. which may be near the table
holes.
2. While holding the arm with both hands, gently return the
machine head to the upright position.
CAUTION
Do not connect the power cord until installation is
complete. The machine may operate if the treadle is
depressed by mistake, which could result in injury.
Use both hands to hold the machine head when
tilting it back or returning it to its original position. If
only one hand is used, the weight of the machine
head may cause your hand to slip, and your hand
may get caught.
Z-8550A, 8560A
4. INSTALLATION
3349M
3350M
3351M
3352M
4