Connecting The Cords; Opening The Control Box Cover - Brother Z-8550A Instruction Manual

4-4. Connecting the cords

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
Contact your Brother dealer or a qualified electrician for any electrical work that may need to be done.
Do not connect the power cord until all cords have been connected.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
sure to connect the ground. If the ground connection is not secure, you run a high risk of receiving a serious electric
shock, and problems with correct operation may also occur.

4-4-1. Opening the control box cover

4-4-2. Connecting the cords
<Removal>
Press the tab.
<Securing>
Cords
DANGER
CAUTION
Loosen
Z-8550A, 8560A
(1) Screw [6 pcs: With washer]
(2) Cover
3366M
1. Sewing machine cords
(1) Repeat cable tie
3367M
4. INSTALLATION
10