Test Operation (Operating The Treadle); Turning On The Power - Brother Z-8550A Instruction Manual

4. INSTALLATION

4-5. Test operation (Operating the treadle)

Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.

4-5-1. Turning on the power

• Release the treadle when turning on the power.
(If the treadle is depressed, "Err 95" will appear in the main display. At this time, "PoFF" will appear when you take your
foot off the treadle, so turn the power off and back on again.)
• After the power is turned on, the subsequent operation of the sewing machine will vary according to the needle bar position
at that time.
2114M
2114M
Panel setting status
• The panel setting status will be the same status that was active at the time the power was last turned off.
• The pattern number will appear in the main display while the buzzer is sounding, and after that the zigzag width and zigzag
base line position will appear.
13
CAUTION
<If the needle bar is at the needle up stop position>
Turn on the POWER switch (1).
Illuminate
The buzzer will sound for about one second, and then the
needle bar will move horizontally to the sewing start position.
Sewing will then be possible.
3373M
<If the needle bar is not at the needle up stop position>
1. Turn on the POWER switch(1). The buzzer will sound for
about one second, and then " UP " will appear in the
main display (2).
2. Turn the machine pulley slowly to move the needle bar to
the needle up stop position. (Align the reference line (3)
Illuminate
on the sewing machine pulley within the indent (4) in the
motor cover.)
The needle bar will then move horizontally to the sewing
start position and sewing will then be possible.
3374M
Z-8550A, 8560A