Symantec 20032623 - Endpoint Protection Small Business Edition Implementation Manual page 97

Upgrading and migrating to Symantec Endpoint Protection Small Business Edition
6
If you select the remote push option, you add computers to the Install
Protection Client list and then click Next. To select computers, you either
browse for computers, or search by IP address or computer name. To search,
click Search Network > Find Computers and either enter IP addresses or the
computer name. When the computers are located, click Next.
Note: You must provide the credentials for a member of the administrator's
group that is authorized to manage the target computers.
7 To complete the push deployment process, click Send.
Note: The wizard creates the package, which can take two or three minutes.
During this time, no progress is indicated. After the package is created,
progress advances as the package is copied to the selected computers. It can
take several minutes to send the package over the network. When the progress
shows 100%, the client package is fully copied on the selected computers and
the installer starts on the client computer. The wizard does not show the
progress of the actual installation process. Go to Reports > Report Type >
Computer Status > Deployment Report to gauge the progress of client
installation.
8 Click Finish
Upgrading clients by using AutoUpgrade
97