Hard Drive Drawer Bezel - HP StorageWorks 600 - Modular Disk System Maintenance And Service Manual

Remove the hard drive.
2.
To replace the component:
Fully extend the hard drive lever.
1.
Push the hard drive all the way into the drive bay, and then close the lever.
2.

Hard drive drawer bezel

To remove the component:
Power down the MDS600
1.
Extend the hard drive drawer (on page 25).
2.
To access the screws securing the bezel to the hard drive drawer, remove the hard drives in device
3.
bays 2 and 7.
For the location of these device bays, see "Device bay ID numbers (on page 57)."
CAUTION:
bays they were removed from.
IMPORTANT:
when removing them.
("Power down" on page 25).
To avoid data loss, be sure that the drives are labeled and returned to the same
The screws are different lengths. Be sure to note the location of each screw
Removal and replacement procedures 28