HP StorageWorks 600 - Modular Disk System Maintenance And Service Manual page 38

Push the drawer in about 25 cm (10 in).
3.
Release the cable management arm and expand to the rear of the chassis.
4.
Push the drawer in another 25 cm (10 in).
5.
Install the power block
6.
WARNING: Pinch hazard—Keep hands out of front and rear of chassis when closing hard
drive drawers.
Install the hard drives.
7.
Be sure that the drives are returned to the drive bays they were removed from.
Close the drawer.
8.
Install all rear panel components.
9.
Connect the cables.
10.
("Power block" on page 39).
Removal and replacement procedures 38