Hard Drive Drawer Bezel; Hard Drive Drawer Display Board - HP StorageWorks 9100 - Extreme Data Storage System Maintenance And Service Manual

Hard drive drawer bezel

To remove the component:
Power down the MDS600
1.
Extend the hard drive drawer (on page 25).
2.
Remove the hard drives in device bays 2 and 7
3.
For the location of these device bays, see "Device bay ID numbers (on page 52)."
IMPORTANT:
removing them.
Remove the eight T-8 Torx screws securing the bezel to the hard drive drawer.
4.
Be sure the drawer handle is in the down position.
5.
Lean the bezel forward, and then remove it from the hard drive drawer.
6.
To replace the component, reverse the removal procedure. The screws are different lengths. Be sure they
are installed in the proper location.

Hard drive drawer display board

To remove the component:
Power down the MDS600
1.
Disconnect the power cord from the AC source.
2.
Extend the hard drive drawer (on page 25).
3.
Remove the hard drives in device bays 2 and 7
4.
For the location of these device bays, see "Device bay ID numbers (on page 52)."
Remove the hard drive drawer bezel
5.
("Power down" on page 24).
The screws are different lengths. Be sure to note the location of each screw when
("Power down" on page 24).
("Hard drive drawer
("Hard drive" on page 26).
("Hard drive" on page 26).
bezel" on page 27).
Removal and replacement procedures 27