Ipv6 Dhcp Relay-Agent-Info-Opt - Enterasys C3G124-24 Configuration Manual

Parameters
None.
Defaults
By default, DHCPv6 is disabled.
Mode
Router global configuration: C3(su)->router(Config)#
Usage
Use this command to enable DHCPv6 on the router. Use the no form of this command to disable
DHCPv6 after it has been enabled.
Example
This example enables DHCPv6.
C3(su)->router(Config)# ipv6 dhcp enable

ipv6 dhcp relay-agent-info-opt

This command configures a number to represent the DHCPv6 Relay Agent Information Option.
Syntax
ipv6 dhcp relay-agent-info-opt option
Parameters
option
Defaults
The default value of the DHCPv6 Relay Agent Information Option is 32.
Mode
Router global configuration: C3(su)->router(Config)#
Usage
The DHCPv6 Relay Agent Information Option allows for various sub-options to be attached to
messages that are being relayed by the local router to a relay server. The relay server may in turn
use this information in determining an address to assign to a DHCPv6 client. Refer to RFC 3046 for
more information.
Example
This example sets the Relay Agent Information Option value to 82.
C3(su)->router(Config)# ipv6 dhcp relay-agent-info-opt 82
The value of option may range from 32 to 65535. The default value is 32.
ipv6 dhcp relay-agent-info-opt
Enterasys C3 Configuration Guide 30-3