Clear Txqmonitor - Enterasys C3G124-24 Configuration Manual

Transmit Queue Monitoring Configuration
Parameters
logging
ignorepause
disableinterface
value
Defaults
logging: 2 sequential failures
ignorepause: 5 sequential failures
disableinterface: 10 sequential failures
Mode
Switch command, read-write.
Example
This example sets the disable interface threshold to 6 sequential failed sample intervals.
C3(su)-> set txqmonitor threshold disableinterface 6

clear txqmonitor

Use this command to restore all transmit queue monitoring options to their default values.
Syntax
clear txqmonitor { all | globalstate | ignorepause [port-string] |
down [port-string] | threshhold | downtime | minrate }
Parameters
all
globalstate
ignorepause
[port-string]
down [port-string]
threshold
downtime
minrate
9-4
Specifies the logging trigger level.
Specifies the discard received pause frames trigger level.
Specifies the port disable trigger level.
The number of successive failed sample intervals that will trigger an
action. A value of 0 disables the associated action.
Clear all transmit queue monitoring options to their default values.
Clear the global state to the default of enabled.
Restore ports in the discarding pause frame state to the default of not
discarding pause frames.
Optionally, restore only specified port or ports.
Re-enable ports disabled by transmit queue monitoring.
Optionally, enable only specified port or ports.
Clear all trigger thresholds to default values. See
threshold for default values.
Clear the downtime value to the default of 0, meaning that disabled
ports will remain disabled until cleared manually or until their next link
state transition.
Clear the number of packets per second that must be transmitted per
sampling interval to the default value of 1 packet per second.
clear txqmonitor
set txqmonitor