Default-Metric - Enterasys C3G124-24 Configuration Manual

Defaults
A default external route is not generated.
The default metric is unspecified.
The default type is type 2.
Mode
Router OSPFv3 configuration: C3(su)->router(Config-router)#
Usage
Use this command to generate a default external route into an OSPFv3 routing domain. Use the no
form of this command to stop the generation of a default external route.
Example
This example specifies a metric of 100 for the default route redistributed into the OSPFv3 routing
domain, and an external metric type of 1.
C3(su)->router(Config-router)# default-information originate metric 100
metric-type 1

default-metric

This command sets a default metric for routes redistributed from another protocol into OSPFv3.
Syntax
default-metric metric
no default-metric
Parameters
metric
Defaults
No default metric is configured.
Mode
Router OSPFv3 configuration: C3
Usage
Use this command to cause the same metric value to be used for all redistributed routes.
Use the no form of this command to remove a configured default metric.
Example
This example configures a metric of 100 to be used for all redistributed routes.
C3(su)->router(Config-router)# default-metric 100
The value of metric can range from 1 to 16777214.
(su)->router(Config-router)#
default-metric
Enterasys C3 Configuration Guide 31-5