Chapter 1: Introduction; Enterasys C3 Cli Overview; Switch Management Methods - Enterasys C3G124-24 Configuration Manual

This chapter provides an overview of the Enterasys C3's unique features and functionality, an
overview of the tasks that may be accomplished using the CLI interface, an overview of ways to
manage the switch, factory default settings, and information about how to use the Command Line
Interface to configure the switch.
For information about...

Enterasys C3 CLI Overview

Switch Management Methods

Factory Default Settings
Using the Command Line Interface
Enterasys C3 CLI Overview
The Enterasys Networks Enterasys C3 CLI interface allows you to perform a variety of network
management tasks, including the following:
• Use CLI commands to perform network management and switch configuration operations.
• Download a new firmware image.
• Assign IP address and subnet mask.
• Select a default gateway.
• Establish and manage Virtual Local Area Networks (VLANs).
• Establish and manage policy profiles and classifications.
• Establish and manage priority classification.
• Configure IPv4 routing and routing protocols.
• Configure IPv6 routing and routing protocols, including OSPFv3.
• Configure security protocols, including 802.1X and RADIUS, SSHv2, PWA, MAC locking, and
MAC authentication.
• Configure access control lists (ACLs).
Switch Management Methods
The Enterasys C3 switch can be managed using the following methods:
• Locally using a VT type terminal connected to the console port.
• Remotely using a VT type terminal connected through a modem.
1
Introduction
Refer to page...
1-1
1-1
1-2
1-6
Enterasys C3 Configuration Guide 1-1