Checking The Sewing Pattern (Ke-430F) - Brother KE-430F Instruction Manual

5. USING THE OPERATION PANEL (BASIC OPERATIONS)

5-4. Checking the sewing pattern (KE-430F)

Use test feed mode to check the needle movement with only the work clamp operating.
Check that the needle hole does not come out from the frame of the work clamp.
1
2 Start continuous test feed mode.
4441Q
[Test interrupt mode]
TEST indicator flashes
[Paused sewing standby mode]
TEST indicator switches off
Once the test feed reaches the final stitch, the work
3
clamp stops moving.
4
1st step
41
TEST indicator lights
For example, program
number 2
Program No. flashes
2nd step
2nd step
・ If you press the
move forward by one stitch, and if you press the
clamp will move back by one stitch. (It will move quicker if you keep the
key pressed down.）
・ If you press the RESET key, the work clamp will return to the sewing
start position.
TEST indicator switches off
1. Press the TEST key.
•
The number of stitches remaining until the final stitch
will be displayed in the menu display.
2. Press the
that you would like to check.
If the PROGRAM No. display is flashing, depress the foot
switch to the 2nd step.
・ The feed mechanism will move to the home position
and the program number will change from flashing to
illuminated.
2nd step
illuminates
Depress the foot switch to the 2nd step and then release it.
・ The work clamp will start moving continuously one
stitch at a time.
(The stitch number display will be decremented by
one stitch at a time.)
・ The TEST indicator will flash.
[Fast-forward test mode]
If you depress the foot switch to the 1st step while the
work clamp is moving, the feeding speed will become
faster while the foot switch is being depressed.
If you would like the work clamp to stop moving, press
the TEST key.
・ When the foot switch is depressed to the 2nd step,
the work clamp will start moving again.
If you would like sewing to resume from the point where it
was paused, press the TEST key while test feeding is
paused to switch off the TEST indicator.
・ When you depress the foot switch to the 2nd step,
sewing will start.
key (2) while in this mode, the work clamp will
Press the TEST key.
Depress the foot switch to the 1st step.
The work clamp will rise and the preparation for sewing
will be completed.
KE-430F, BE-438F
or key (1) to set the program number
2404B 2416B 4441Q
key (3), the work
2416B
2415B 4441Q
2417B
2404B
4441Q