Download  Print this page

Resetting All Settings To Their Defaults - Brother KE-430F Instruction Manual

Electronic direct drive lockstitch bar tacker electronic direct drive lockstitch button sewer.
Hide thumbs

Advertisement

6-7. Resetting all settings to their defaults

If the sewing machine stops operating normally, the cause may be that an incorrect setting may have been made for the memory
data by means of memory switches, for instance. In such cases, it may be possible to restore normal operation by following the
steps given below to initialize the memory setting data.
Change to initialization mode.
1
(While pressing the RESET key, press the power ON
switch.)
2
3
'1' will be displayed in the PROGRAM No. display, and 'ALL' will
be displayed in the menu display.
[Reference]
If the
or
key (1) is pressed at this time, you can select the items to be initialized
as shown below.
* For details on initialization items other than "init ALL", refer to the service manual.
PROGRAM
No. display
1
2
3
4
5
6
7
*1: P001 and P199 are displayed alternately.
*2: P200 and P999 are displayed alternately.
*3: Additional patterns will also be cleared, so check that a backup exists before
clearing them.
Press the ENTER key for two seconds or more.
• The menu display will change to illuminated and initialization will then be
complete.
Press the TEST key.
KE-430F, BE-438F
6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
Main display
All data in memory is cleared or initialized.
「ALL」
(*3)
The values for each parameter in program
*1
No. 1 to 199 set as described in "5-2.
Program setting method" are initialized.
*2
Program numbers 200 to 999 are cleared.
All programs are cleared or initialized.
「PALL」
Cycle programs are cleared.
「CYCL」
Memory switches are initialized.
「MEM」
Additional patterns are cleared.
「PDAT」
Initialization item
2447B 2138M 2139M
2446B
2448B
2404B
54

Advertisement

Table of Contents

   Related Manuals for Brother KE-430F

This manual is also suitable for:

Be-438fKe-430f series

Comments to this Manuals

Symbols: 0
Latest comments: