Brother KE-430F Instruction Manual page 84

Electronic direct drive lockstitch bar tacker electronic direct drive lockstitch button sewer
Hide thumbs Also See for KE-430F:
Table of Contents

Advertisement

10. TABLE OF ERROR CODES
Data editing-related errors
Code
The enlargement ratio setting caused the sewing data to extend outside the sewing area.
E500
Press the RESET key to clear the error.
Set the enlargement ratio again.
The enlargement ratio caused the data pitch to exceed the maximum pitch of 12.7 mm.
E502
Press the RESET key to clear the error.
Set the enlargement ratio again.
Error in pattern data.
E510
Press the RESET key to clear the error.
Re-read the pattern data from the media, or recreate the pattern data.
No end code has been input into pattern data.
E511
Press the RESET key to clear the error.
Recreate the pattern data containing the end code, or change the pattern number being read.
Number of stitches exceeds allowed maximum.
E512
Press the RESET key to clear the error.
Change the number of the pattern being read.
Memory switch file cannot be read correctly.
Copy source model and copy destination model are incorrect. (Maybe the 430F is attempting to read data for the
E581
438F.)
Press the RESET key to clear the error.
Read data for the same sewing machine model.
Memory switch versions do not match.
E582
Press the RESET key to clear the error.
Read data for the same version.
Parameter versions do not match.
E583
Press the RESET key to clear the error.
Read data for the same version.
Device-related errors
Code
Thread nipper motor home position cannot be detected. Problem with thread nipper motor or poor thread nipper
encoder connection.
E690
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps.
Check that connector P20 on the main P.C. board is properly connected.
Thread nipper retract position error.
Check if the upper thread trailing length is too long.
E691
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps.
Check that connectors P20 and P4 on the main P.C. board are properly connected.
P.C. board-related errors
Code
Abnormal rise in power supply voltage.
E700
Turn off the power and check the input voltage.
Abnormal rise in sewing machine motor drive voltage.
E701
Turn off the power, and then check the voltage.
Abnormal drop in power supply voltage.
E705
Turn off the power and check the input voltage.
Abnormal current detected in sewing machine motor.
E710
Turn off the power, and then check if there are any problems with the sewing machine.
Abnormal current detected in pulse motor.
E711
Turn off the power, and then check if there are any problems with the work clamp/button clamp operation.
If an error code that is not listed above appears or if carrying out the specified remedy does not solve
the problem, contact the place of purchase.
75
Cause and remedy
Cause and remedy
Cause and remedy
KE-430F, BE-438F

Advertisement

Table of Contents
loading

This manual is also suitable for:

Be-438fKe-430f series

Table of Contents