Appendix A: Integration And Usage Tips - Intel S1200BTS Specification

Intel® Server Board S1200BT TPS

Appendix A: Integration and Usage Tips


When adding or removing components or peripherals from the server board, AC power
must be removed. With AC power plugged into the server board, 5-Volt standby is still
present even though the server board is powered off.

When updating BIOS and BMC, AC power must be on.

Supports only Intel
Processor i3-2100 and less Thermal Design Power (TDP). Does not support previous
generations of the Intel

On the back edge of the server board are diagnostic LEDs that display a sequence of
amber POST codes during the boot process. If the server board hangs during POST,
the LEDs display the last POST event run before the hang.

Supports only unbuffered DDR3 DIMMs (UDIMMs). Does not support the mixing of
RDIMMs and UDIMMs.
®

The Intel Remote Management Module 4 (Intel
®
with the Intel
Remote Management Module 2 (Product Order Code - AXXRMM2) or Intel
Management Module 3 (Product Order Code – AXXRMM3)

Clear the CMOS with the AC power cord plugged in. Removing the AC power before
performing the CMOS clear operation causes the system to automatically power up and
immediately power down after the CMOS clear procedure is followed and AC power is
re-applied. If this happens, remove the AC power cord, wait 30 seconds, and then re-
connect the AC power cord. Power up the system and proceed to the <F2> BIOS Setup
utility to reset the needed settings.

Normal Integrated BMC functionality is disabled with the force Integrated BMC update
jumper set to the ―enabled‖ position (pins 2-3). The server should never be run with the
Integrated BMC force update jumper set in this position and should only be used when
the standard firmware update process fails. This jumper should remain in the default
(disabled) position (pins 1-2) when the server is running normally.

When performing a normal BIOS update procedure, the BIOS recovery jumper must be
set to its default position (pins 1-2).
Revision 1.0
® ®
Xeon Processor E3-1200 Series with 95 W or Intel
® ®
Xeon processor.
Remote Management Module (Product Order Code - AXXRMM), Intel
Intel order number G13326-003
Appendix A: Integration and Usage Tips
®
RMM4) lite connector is not compatible
®
Core™
®
®
Remote
119