200/208V Pdu Rack Power Configurations - HP D7171A - NetServer - LPr Manual

Chapter 2
Two 120 V PDUs per UPS Possible
Two 120 VAC PDUs can be plugged into the UPS in this 120 V power
configuration. There are also six NEMA 5-15R receptacles in the standard UPS
which can be used for equipment in the same rack if needed.

200/208V PDU Rack Power Configurations

The 208 VAC PDU power configurations appear as shown below in Table
and Figure 9.
2-
Recommended 208 VAC Power Configurations
In the United States, if you are using a UPS use PDU model E7671A or E7672A.
Attach the IEC 320 C19 end of the E7801A cord to the PDU and attach the
L6-20 end of the same cord to the NEMA L6-20 receptacle on the UPS.
Alternate 208 VAC Power Configurations
In the 208 VAC case, without a UPS, make sure your power system has the
capacity to support the power and current needs of the components you will
power (see the section titled "Site Preparation: Circuit Breakers "). If power and
current capacity are adequate, plug the PDU into a 208 V, L6-20 receptacle.
32
Connecting and Routing Cables to the HP NetServer LH 4r
5
2-