HP D7171A - NetServer - LPr Manual page 9

Chapter 1
NOTE HP Rack System product numbers J1487B, J1487B option
AXH, and J1488A require that enclosures to be tied together
before any components are mounted inside them. To avoid
problems, if these rack versions are to be tied together, do so
before installing slide members, rails, shelves, units, or other
hardware. Otherwise, you may have to remove components
from the rack to gain access to the tie-bolt locations.
2. If present, remove the front and rear doors to increase accessibility inside
the rack. Follow instructions shipped with the rack to do so.
NOTE
HP Rack System product numbers J1487B, J1487B option
AXH, and J1488A require door hardware to be in place before
mounting components. If you are using front or rear doors, be
sure the hinge and latch hardware is mounted before putting
on any other hardware. This prevents later disassembly.
WARNING
When the back door of a rack is removed, the latch catch
bracket protrudes. To avoid injury, temporarily remove this
bracket prior to installing components into the rear of the
rack.
3. If present, remove side panels to allow better access. Follow instructions
shipped with the rack to do so.
Install Fans If Required and UPS First If You Have Them
1. If an extractor fan unit is to be used, install it following instructions which
accompany the unit.
NOTE
If your server has an internal fan system, your rack doors must
be perforated (front and/or rear). In this case, you do not need
an extractor fan.
2. If an Uninterruptible Power Supply (UPS) is used, install the UPS
mounting rails and fasten the unit into place following instructions which
accompany it. Place the UPS equipment in the lowest EIA Units of the
rack. Plug the UPS in to charge the batteries as soon as possible.
About This Cabling Reference
5