Configuring Fabric Parameters; Enabling Insistent Domain Id Mode (Ficon Only); Configure Tab, Fabric Subtab - HP StorageWorks 2/64 - Core Switch Administrator's Manual

Configure tab, Fabric subtab

Figure 9

Configuring fabric parameters

1. Launch the Switch Admin module as described on
2. Disable the switch as described in
3. Click the Configure tab.
4. Click the Fabric subtab.
5. Make the fabric parameter configuration changes.
6. Click Apply.
7. Enable the switch as described in

Enabling insistent domain ID mode (FICON only)

When insistent domain ID (ID_ID) mode is enabled, the current domain setting for the switch is insistent;
that is, the same ID is requested during switch reboots, power cycles, CP failovers, firmware downloads,
and fabric reconfigurations. If the fabric does not assign the insistent domain ID, the switch segments from
the fabric.
This parameter is for use with FICON only.
Launch the Switch Admin module as described on
1.
2. Disable the switch as described in
3. Click the Configure tab.
4. Click the Fabric subtab.
5. Check the Insistent Domain ID Mode check box.
6. Click Apply.
7. Enable the switch as described in
42 Managing your fabrics, switches, and ports
page 36.
"Enabling and disabling a
"Enabling and disabling a
page 36.
"Enabling and disabling a
"Enabling and disabling a
switch" on page 39.
switch" on page 39.
switch" on page 39.
switch" on page 39.