Configuring system services
1.
Launch the Switch Admin module as described on
2.
Disable the switch as described in
3.
Click the Configure tab.
4.
Click the System subtab.
5.
Select the boxes next to the system services that you want to enable. Clear a box to disable a service.
NOTE:
Selecting the Disable RLS Probing box disables RLS probing. Clearing this box enables RLS
probing.
6.
Click Apply.
7.
Enable the switch as described in
Configuring ports
Use the Ports tab of the Switch Admin module to perform the basic port configuration procedures
described in this section.
Figure 10
Ports tab
44
Managing your fabrics, switches, and ports
"Enabling and disabling a
"Enabling and disabling a
Figure 10
shows an example of the Ports tab.
page
36.
switch" on page 39.
switch" on page 39.