The Dispense Mode - Oki LP470b User Manual

The Dispense Mode

You can select Dispense Mode for linerless labels by using the
printer setting tool.
Configuring the Dispense Mode
Dispense Mode can be set to Auto Print or Manual Print (the
default setting), as described below.
Type
Auto Print Prints one label after receiving data and waits for
peeling. After the label is peeled off, the printer
automatically prints the next label.
Manual Prints one label after receiving data and goes offline.
Print Press the PRINT key to print the next label. After printing
the specified number of labels, printing terminates. No
printing occurs even when the PRINT key is pressed.
To switch between Auto or Manual Print for the Dispense Mode,
set the DIP switches and then hold down the PRINT or FEED
button when turning the printer ON. The new settings take
effect when the printer is next turned ON.
Switching from Manual to Auto Print
1. Turn the printer off.
2. Make sure DIP switches 1-2-3-4 are set to OFF-OFF-OFF-ON.
3. Open the cover.
4. Press and hold the PRINT button while turning the printer on.
5. Close the cover.
Switching from Auto to Manual Print
1. Turn the printer off.
2. Make sure DIP switches 1-2-3-4 are set to OFF-OFF-OFF-ON.
3. Open the cover.
4. Press and hold the FEED button while turning the printer on.
5. Close the cover.
When you switch to the Dispense mode, the STATUS LED blinks
green, and turns into a steady green signal upon completion of
Description
52