• When the onboard buzzer is enabled, it will sound when the
printer is turned ON during DIP switch setting. Release the
FEED button to stop the buzzer.
• To end any setting for Standard/Non-standard Control Code
or Peeling Print or Online Command compatibility, confirm
that the STATUS LED is lit green. Then turn the printer OFF,
and reset the DIP switches as necessary.
Note: Some hosts monitor the Request-To-Send (RTS) signal
(pin 4 of 25) to determine if the printer is ready to receive
data. Since the printer does not generate this signal, the
RTS pin must be connected to the Clear-To-Send (CTS)
pin (pin 5 of 25)
57