Supero 6027R-3RF4 User Manual page 56

S S
UPER ERVER 6027R-3RF4+ User's Manual
Watch Dog Enable/Disable
Jumper JWD controls the Watch
Dog function. Watch Dog is a sys-
tem monitor that can reboot the
system when a software application
hangs. Jumping pins 1-2 will cause
WD to reset the system if an appli-
cation hangs. Jumping pins 2-3 will
generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user
needs to write their own applica-
tion software in order to disable the
Watch Dog Timer.
JTAG Scan
The JTAG scan jumpers (JPP0/
JPP1) allow the user to confi gure
JTAG scan settings for system de-
bugging. See the tables on the right
for jumper settings.
Watch Dog
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
JTAG Scan (JPP0)
Jumper Settings
Jumper Setting Defi nition
Pins 1/2, 3/4 including CPU2 in JTAG Scan
Pins 2/3 (Default) JTAG Scan: CPU1 only
JTAG Scan (JPP1)
Jumper Settings
Jumper Setting Defi nition
Pins 1/2, 3/4 including CPU1 in JTAG Scan
Pins 2/3 (Default) JTAG Scan: CPU2 only
5-26
Defi nition
Reset
NMI
Disabled