Table of Contents
Advertisement
NIC2 (LAN2) LED
The LED connections for LAN2 are on pins
9 and 10 of JF1. Attach LAN LED cables to
display network activity. See the table on the
right for pin defi nitions.
NIC1 (LAN1) LED
The LED connections for LAN1 are on pins
11 and 12 of JF1. Attach LAN LED cables to
display network activity. See the table on the
right for pin defi nitions.
HDD LED
The HDD LED connection is located on pins
13 and 14 of JF1. Attach the hard drive LED
cable here to display disk activity (for any
hard drives on the system, including SAS,
Serial ATA and IDE). See the table on the
right for pin defi nitions
Power On LED
The Power On LED connector is located
on pins 15 and 16 of JF1. This connection
is used to provide LED indication of power
being supplied to the system. See the table
on the right for pin defi nitions.
NMI Button
The non-maskable interrupt button header is
located on pins 19 and 20 of JF1. Refer to the
table on the right for pin defi nitions.
LAN1/2 (Ethernet Ports)
Two Gigabit Ethernet ports (designated
LAN1 and LAN2) are located beside the
VGA port. Additionally, there is a dedicated
LAN poor for IPMI beside the two rear USB
ports. These Ethernet ports accept RJ45
type cables.
Chapter 5: Advanced Motherboard Setup
NIC2 LED
Pin Defi nitions
Pin# Defi nition
9
10
NIC1 LED
Pin Defi nitions
Pin# Defi nition
11
12
HDD LED
Pin Defi nitions
Pin# Defi nition
13
14
Power LED
Pin Defi nitions
Pin# Defi nition
15
16
NMI Button
Pin Defi nitions
Pin# Defi nition
19
20
5-15
(JF1)
Vcc
Ground
(JF1)
Vcc
Ground
(JF1)
Vcc
HD Active
(JF1)
5V Stby
Control
(JF1)
Control
Ground
Advertisement
Table of Contents
