Table of Contents
Advertisement
S
S
UPER
ERVER 1012G-MTF User's Manual
5-6
Installing Memory
CAUTION! Exercise extreme care when installing or removing DIMM
!
modules to prevent any possible damage.
Memory Support
The H8SGL-F supports up to 128 GB of registered ECC DDR3-1333/1066/800
MHz SDRAM or 32 GB of unbuffered ECC/non-ECC DDR3-1333/1066/800 MHz
SDRAM in 8 DIMM slots. See the following table for memory installation. This
serverboard works with LV (Low Voltage) DDR3 DIMM modules, please see the
tested memory list for the H8SGL-F serverboard on the Supermicro motherboard
website for reference.
Memory speed support is dependent on the type of CPU used on the board.
Installing Memory Modules
1.
Insert the desired number of DIMMs into the memory slots, starting with
DIMM 1A. For best memory performance, please install memory modules
of the same type and same speed on the memory slots as indicated on the
tables below.
2.
Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-5).
3.
Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
To Install: Insert
module vertically and
press down until it
snaps into place. Pay
attention to the align-
ment notch at the
bottom.
To Remove: Use
your thumbs to gen-
tly push the release
tabs near both ends
of the module. This
should release it from
the slot.
Figure 5-5. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
5-8
Front View
Note: Notch should align with
the receptive key point on
the slot.
Release Tab
Notch
Advertisement
Table of Contents
