I2C To Pci-Express Slot; Vga Enable/Disable; Lan1/2 Enable/Disable; Onboard Speaker Enable/Disable - Supero SuperServer 1012G-MTF User Manual

S S
UPER ERVER 1012G-MTF User's Manual

I2C to PCI-Express Slot

JI 2 C1/JI 2 C2 allows you to enable the I
to communicate with the PCI-Express slot.
For the jumpers to work properly, please set
both jumpers to the same setting. If enabled,
both jumpers must be enabled. If disabled,
both jumpers must be disabled. See the table
on the right for jumper settings.

VGA Enable/Disable

JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on the
right for jumper settings.

LAN1/2 Enable/Disable

Change the setting of jumper JPL1 or JPL2
to enable or disable the LAN1 or LAN2
Ethernets port. See the table on the right
for jumper settings. The default setting is
enabled.

Onboard Speaker Enable/Disable

The JD1 header allows you to use either an
external speaker or the internal (onboard)
speaker. To use the internal onboard speaker,
close pins 6 and 7 with a jumper. To use an
external speaker, remove the jumper and
connect the speaker wires to pins 4 (+5V)
and 7 (control signal). See the table on the
right for settings and the table associated with
the Power LED/Keylock/Speaker connection
(previous section) for jumper settings.
I 2 C to PCI-Express Slot
Jumper Settings
2 C bus
(JI
Jumper Setting Defi nition
Closed
Open
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
LAN1/2 En/Disable Jumper
Settings (JPL1/JPL2)
Jumper Setting
Pins 1-2
Pins 2-3
Onboard Speaker Enable/Disable
Pin Defi nitions (JD1)
Pins Defi nition
6 and 7 Jump for onboard speaker
4 and 7 Attach external speaker wires
Note: Pins 4-7 are used only for
the onboard speaker.
5-20
2 C1/JI 2 C2)
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled