Table of Contents
Advertisement
S
S
UPER
ERVER 1012G-MTF User's Manual
Unpacking
The motherboard is shipped in antistatic packaging to avoid electrical static
discharge. When unpacking the board, make sure the person handling it is static
protected.
5-2
Motherboard Installation
This section explains the fi rst step of physically mounting the H8SGL-F into the
SC813MTQ-350 chassis. Following the steps in the order given will eliminate
the most common problems encountered in such an installation. To remove the
motherboard, follow the procedure in reverse order.
Installing to the Chassis
1.
Access the inside of the system (see procedure in Chapter 6).
2.
Make sure that the I/O ports on the motherboard align properly with their
respective holes in the I/O shield at the back of the chassis.
3.
Carefully mount the motherboard to the motherboard tray by aligning the
board holes with the raised metal standoffs that are visible in the chassis. You
may need to add an extra standoff for the hole near the Fan 3 header.
4.
Insert screws into all the mounting holes on your motherboard that line up
with the standoffs and tighten until snug (if you screw them in too tight, you
might strip the threads).
5.
Finish by replacing the top cover of the chassis.
Note: Metal screws provide an electrical contact to the serverboard ground to
provide a continuous ground for the system.
Warning: To avoid damaging the serverboard and its components, do not apply any
force greater than 8 lbs. per square inch when installing a screw into a mounting
hole.
5-2
Advertisement
Table of Contents
