Table of Contents
Advertisement
2-1
Overview
This chapter provides a quick setup checklist to get your SuperServer 1012G-MTF
up and running. Following the steps in the order given should enable you to have
the system operational within a minimal amount of time. This quick setup assumes
that your 1012G-MTF system has come to you with the processor and memory
preinstalled. If your system is not already fully integrated with a motherboard,
processor, system memory etc., please turn to the chapter or section noted in each
step for details on installing specifi c components.
2-2
Unpacking the System
You should inspect the box the SuperServer 1012G-MTF was shipped in and note
if it was damaged in any way. If the server itself shows damage, you should fi le a
damage claim with the carrier who delivered it.
Decide on a suitable location for the rack unit that will hold the SuperServer 1012G-
MTF. It should be situated in a clean, dust-free area that is well ventilated. Avoid
areas where heat, electrical noise and electromagnetic fi elds are generated. You
will also need it placed near a grounded power outlet. Read the Rack and Server
Precautions in the next section.
2-3
Preparing for Setup
The box the SuperServer 1012G-MTF was shipped in should include two sets of
rail assemblies, six rail mounting brackets and the mounting screws you will need
to install the system into the rack. Follow the steps in the order given to complete
the installation process in a minimal amount of time. Please read this section in
its entirety before you begin the installation procedure outlined in the sections that
follow.
Chapter 2
Server Installation
2-1
Chapter 2: Server Installation
Advertisement
Table of Contents
