Table of Contents
Advertisement
Checking the Components
1.
You may have the processor already installed into the system board.
The processor should have its own heatsink attached. See Chapter 5 for
instructions on processor installation.
2.
Your 1012G-MTF server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
3.
If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
4.
Make sure all power and data cables are properly connected and not blocking
the airfl ow. See Chapter 5 for details on cable connections.
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SAS/SATA drives
and their backplane have been properly installed and all essential connections
have been made.
1.
Airfl ow is provided by four high-performance 4-cm input fans. The system
component layout was carefully designed to promote suffi cient airfl ow through
the small 1U rackmount space.
Checking the Drives
1.
Check the SAS/SATA disk drives. These drives can be installed and removed
from the front of the chassis without removing the top chassis cover
2.
Follow the steps for "Accessing the Inside of the System" in Section 2-5 to
remove the top chassis cover.
3.
Check the CD-ROM drive. Refer to Chapter 6 if you need to reinstall a DVD-
ROM drive to the system.
Note: Depending upon your system's confi guration, your system may have one
or more drives already installed. If you need to install drives, please refer to the
appropriate section in Chapter 6.
Chapter 2: Server Installation
2-9
Advertisement
Table of Contents
