Advertisement
44
ENABLE IP IGMP ALLGROUP
Syntax
Description
Examples
See Also
Syntax
Description
Examples
See Also
New Commands
This enhancement request introduces two new commands from enabling/
disabling all-group entries on switch ports.
ENABLE IP IGMP ALLGROUP
ENABLE IP IGMP ALLGROUP=[{port-list|ALL}]
where:
■
port-list is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 ad end at m, where m is the highest numbered Ethernet switch port,
including uplink ports.
This command enables the specified port(s) to behave as a multicast all-group
ports.
The ALLGROUP parameter specifies the list of ports able to behave as all-
group entry ports. If ALL is specified, all ports are able to behave as all-group
entry ports. The default is ALL.
To enable ports 1, 5 and 7 to behave as all-group entry ports, use the command:
ENABLE IP IGMP ALLGROUP=1,5,7
DISABLE IP IGMP ALLGROUP
SHOW IP IGMP
DISABLE IP IGMP ALLGROUP
DISABLE IP IGMP ALLGROUP=[{port-list|ALL}]
where:
■
port-list is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 and end at m, where m is the highest numbered Ethernet switch port,
including uplink ports.
This command disables the specified port(s) from acting as a multicast all-
group entry ports. Ports that are disabled have a "#" symbol next to the port
number in the output of the SHOW IP IGMP command.
To prevent ports 1, 5 and 7 from behaving as all-group entry ports, use the
command:
DISABLE IP IGMP ALLGROUP=1,5,7
ENABLE IP IGMP ALLGROUP
SHOW IP IGMP
Patch Release Note
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z
Advertisement
