Download Print this page

Allied Telesis 86222-27 Release Note page 21

Patch for rapier switches

Advertisement

Patch 86222-27 For Rapier Switches
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z
PCR: 02098
Module: STP
STP always transmits untagged packets. If a port does not belong to a
VLAN as an untagged port, then the port must belong to one VLAN as a
tagged port. In this case, STP should transmit VLAN tagged packets out of
the port.
PCR: 02123
Module: IPG
The IP, MASK, and ACTION parameters could not be set with the SET IP
ROUTE FILTER command. This issue is resolved when the filter number is
specified at the start of the command, for example:
SET IP ROUTE FILTER=filter-id IP=ipadd MASK=ipadd
ACTION={INCLUDE|EXCLUDE}
where: filter-id is the filter number. Filter numbers are displayed in the
output of the SHOW IP ROUTE FILTER command.
PCR 02138
Module: SWI
The built in Self Test Code for all Rapiers, except G6, has been improved to
enhance the detection of faults in switch chip external packet memory.
PCR 02140
Module: OSPF
An AS boundary router advertises AS external LSAs to other routers.
However, when the router's configuration changed, either by adding an IP
route filter, or by setting its ASEXTERNAL parameter to OFF using the SET
OSPF ASEXTERNAL command followed by a restart, its neighbour state
could not reach full state. Also, when the router had IP route filters
configured, matched routes were not being flooded into other routers.
However, these routes should still have been imported into the router's
own LSA database, but were not. These issues have been resolved.
PCR 02144
Module: IPG
The IPG module has been enhanced to support gratiutous ARP request and
ARP reply packets.
PCR 02151
Module: IPG
The Rapier was not detecting invalid checksums in ICMP echo request
packets. This issue has been resolved. ICMP echo request packets with
invalid checksums are now dropped and the ICMP inErrors and inDiscards
counters are incremented.
PCR 02164
Module: DHCP
A simple DHCP range MIB and a trap have been added. The trap is
triggered when a DHCP request cannot be satisfied. The gateway address
and the interface address are sent as trap variables. The range table shows
which range was exhausted. A debug variable,
swiDebugBroadcomParityErrors has been added to the SWI module MIB to
count the SDRAM parity errors in the packet memory of the Broadcom
switch chip.
PCR 02176
Module: FIREWALL
Packets traversing in and out of the same public firewall interface were
sometimes blocked. The firewall should only control packets passing
between a public and a private interface. This issue has been resolved.
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting:No
Network affecting: No
Network affecting: No
Network affecting: No
21

Advertisement

loading