Advertisement
set perm
Syntax
SET PERM=perm-name [LPORT=lport] [RPORT=rport] [IP=ipadd]
where:
■
perm-name is the name of the permanent assignment. The name is case sensitive and must be identical on each router in the permanent assignment. If the
name contains spaces, it must be in double quotes.
■
lport is the number of the local asynchronous port for this permanent assignment. Ports are numbered sequentially starting with port 0.
■
rport is the number of the remote asynchronous port for this permanent assignment. Ports are numbered sequentially starting with port 0.
■
ipadd is the IP address of the remote router.
Description
This command changes the configuration of an existing permanent assignment. The permanent assignment must be specified by name. At least one other
parameter must be specified.
The remote end of the permanent assignment must also be configured on the remote router.
Examples
To change the local and remote asynchronous ports used by the permanent assignment called DataLogger to port 0, use the command:
set perm=datalogger lport=0 rport=0
Related Commands
delete perm
reset perm
show perm
Version 276-05
C613-10474-00 REV D
Permanent Assignments (CR00011355)
82
Advertisement
