Advertisement
14
PCR 02408
Module: SWI
The EPORT parameter in the SHOW SWITCH L3FILTER ENTRY command
was displaying incorrectly after an issue was resolved in PCR02374. The
command now displays correctly.
PCR: 02427
Module: DHCP
DHCP entry reclaim checks are now delayed by 10 seconds if the entry is
unroutable because the interface is not up.
PCR: 02463
Module: DVMRP, IPG
Support for multi-homed interfaces has been added.
PCR 02465
Module: TTY
Under some circumstances a fatal error occurred if a large amount of data
was pasted onto the command line. This issue has been resolved.
PCR: 02489
Module: SWI
When the switch was under heavy learning load, some MAC address were
lost. This issue has been resolved.
PCR 02506
Module: OSPF, IPG
In the ADD IP ROUTE FILTER command, when the optional parameter
INTERFACE was included, the filter was not applied to the flooding of
OSPF external LSAs. Also, in the command SHOW IP ROUTE FILTER, the
output of the interface name was truncated when the name was more than
six characters long. These issues have been resolved.
PCR: 02509
Module: DVMRP
The source net mask has been removed from DVMRP prune, graft and
graft-ack messages.
PCR 02526
Module: DVMRP
Under some circumstances, multiple default routes were created for
DVMRP. This issue has been resolved.
PCR 02538
Module: DVMRP
The source mask is now always 0xffffffff in the DVMRP forwarding table.
The temporary route in the DVMRP route table was not displaying
correctly. This issue has been resolved.
An IGMP entry was erroneously added for the reserved IP address. This
issue has been resolved.
Patch Release Note
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z
Advertisement
