Download Print this page

Allied Telesis 86222-27 Release Note page 28

Patch for rapier switches

Advertisement

28
PCR: 01272
Module: SWI
A physical port could not be re-enabled once disabled when STP was active.
This issue has been resolved.
PCR: 01273
Module: SWI
The CREATE CONFIG command now includes the STPFORWARDING
parameter in generated scripts. The SHOW SWITCH command now
displays the setting of STPFORWARDING.
PCR: 01274
Module: SWI
Refinements were made to the switch chip register settings improving CoS
provision with the newer revision of switching silicon on the Rapier 16,
Rapier 24 and Rapier 48.
PCR: 01275
Module: FIREWALL
The firewall was incorrectly forwarding multicast packets originating from
a private address in cases where a matching route was defined. This issue
has been resolved.
PCR: 01276
Module: SWI
When the speed of one or more switch ports was forced to a half duplex
setting and the ports were then added to a trunk group configured for full
duplex operation, the port settings were not overridden by the trunk group
speed setting. The trunk group speed setting will now take precedence over
the port speed setting.
PCR: 01287
Module: OSPF
Configuring IP route filters did not stop flooding of AS external LSAs to
neigbours at startup. The result was that the neigbour received the AS LSAs
and added the corresponding routes into its own routing table. However,
after some time (e.g. 1 hour), the AS external LSAs in the neigbour's
database disappeared, but the corresponding routes were still in its routing
table. This issue has been resolved.
PCR: 01289
Module: VRRP
The checksum in VRRP advertisements was not being calculated correctly.
The calculation was not compatible with the RFC. This issue has been
resolved.
PCR: 01290
Module: PPP
When PPP was running over Ethernet to a client from another vendor, the
Maximum Transmission Unit value for the link was not adjusted from the
PPP default of 1500 to 1492. This issue has been resolved.
PCR: 01291
Module: IPG(IGMP)
IGMP did not send the Start Up Query, and the Other Querier Present Timer
did not change the Time Out value accordingly if Query Interval was
changed. IGMP did not notify other registered parties (PIM and DVMRP)
when a port was deleted from a membership group. IGMP reported a
membership leave to other parties while it was still waiting for a reply to a
group specific query from a leaving member. These issues have been
resolved.
Patch Release Note
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z

Advertisement

loading