Pedestal Removal; Remove Covers; Remove Pedestal - HP D5970A - NetServer - LCII User Manual

Chapter 5

Pedestal Removal

An anti-tip pedestal is shipped with each LC 3.
You must remove the anti-tip pedestal (if it is installed) from the HP NetServer
before you install it in a rack assembly. You may also need to remove it to
facilitate shipping the HP NetServer. To remove the pedestal, first remove the HP
NetServer covers, and then detach the pedestal and lift the HP NetServer off it, as
described in "Remove Covers" and "Remove Pedestal" below.
After the pedestal is removed, you may mount the HP NetServer in a rack
assembly, as instructed in the next section of this chapter.
If you are shipping the NetServer to another location, before packing it,
replace all covers and the front bezel. See "Replace All Covers . . ." in
Chapter 1, "Installation Overview."

Remove Covers

1. Turn off the HP NetServer, and disconnect the power cord and all other
cables.
2. Remove the front bezel, top cover, and one or both side covers, as
described in Chapter 1: "Installation Overview."

Remove Pedestal

1. Depress the two plastic buttons that protrude through the metal base plate
of the HP NetServer, as shown in Figure 5-1.
36
Installation in Rack (Optional)