Install Additional Memory - HP D5970A - NetServer - LCII User Manual

Chapter 1
c. Push the top cover back, and lift it off. The Technical Reference Label
is inside the top cover.
5. If you are installing any accessory boards or additional mass storage
devices (other than hot-swap disk drive modules), also remove the side
cover farthest from the system board (See Figure 1-1, Step D.):
a. Grasp the two tabs at the top of the side cover.
b. Pull upward and outward to lift the side cover off.
CAUTION Handle the side cover only by its top and bottom edges to
avoid damaging the EMI spring fingers inside its side edges.

Install Additional Memory

CAUTION
The LC 3 uses 100 MHz SDRAM DIMMs, which are
electrically different from the EDO memory modules used
with earlier models. (Even though the EDO DIMM from
earlier models does fit in the DIMM sockets, it does not
function.) Do not install EDO DIMMs from previous models
in the LC 3.
CAUTION
Use only DIMMs acquired from HP. Refer to the following
for a list of qualified DIMMs:
When handling DIMMs, observe antistatic precautions to
avoid damage.
Technical Reference Label inside the HP NetServer top
cover
HP Order Assistant on the HP Web Site at
http://www.hp.com/go/netserver
Information Assistant on the HP Navigator CD-ROM
HP Customer Service
Installation Overview
5