Error Message Is Displayed - HP D5970A - NetServer - LCII User Manual

Chapter 6
4. Restart the system. If the system does not function, refer to one of the
following sections, depending upon whether an error message is
displayed:

"Error Message Is Displayed"

"No Error Message Displayed"
5. If the system still will not restart, clear the system configuration memory
and restart the system, as described in "Clearing the System
Configuration."
Error Message Is Displayed
There are two kinds of error messages that may prevent the HP NetServer from
booting. These are:
Highlighted error messages (white text on gray background). Press
ENTER to see a definition of the message and what action to take to
remedy the problem.
Error messages displayed in normal video.
If an HP NetServer configuration error is reported during the startup routine,
clear the system configuration memory and reconfigure as described under
"Clearing the System Configuration," and restart the HP NetServer.
Power-On System Hardware Test Error Messages
If an error occurs during the power-on system hardware test (POST) when the HP
NetServer starts, press ENTER to view system error to display details of the
error. Follow the instructions on the screen. Correct the error before proceeding,
even if the HP NetServer appears to start successfully.
If the HP NetServer starts, but the power-on system hardware test still reports an
error message, clear the system configuration memory, as described in "Clearing
the System Configuration."
The following table describes common errors and the corrective action you may
take to remedy the problem:
48
Troubleshooting